1) Clean application surface thoroughly with application fluid.

NOTE: NEVER USE AMMONIA BASED CLEANERS (i.e. Windex). It will out gas for a couple of weeks and create bubbles under the decal. Which will result in accidental decal peeling.

2) WITHOUT PULLING OFF THE BACKING PAPER, Secure masking tape on each side of your decal and place on the windshield surface.

3) Place a longer piece of masking tape at the middle (To insure an easier install, try to place the tape between the spaces of the vinyl graphic).

4) Pull backing paper off by either ripping or cutting off half of the backing paper with a razor/exacto knife.

5) Carefully squeegee the decal onto the surface starting from the middle and ending at the edge closest to you.

6) Now that half of your decal is secure, peel the backing paper off of the rest of your decal and carefully squeegee the decal onto the surface starting from the middle and ending at the edge closest to you.

7) Finally, gently remove application tape by pulling straight back, leaving the decal on the surface.