Decal Install Guide: Dry Installation on Windshield
Supplies Needed
|
Squeegee (Supplied free with every order)
Application Fluid in Spray Bottle (Mixture of 1 teaspoon of liquid soap in 1 litre of water)
Kitchen paper towel
|
|
Each Decal Consists Of 3 Layers
|
Top layer (application tape)
Middle layer (decal)
Bottom layer (backing wax paper)
|
1)Clean application surface thoroughly with application fluid.
NOTE: NEVER USE AMMONIA BASED CLEANERS (i.e. Windex). It will out gas for a couple of weeks and create bubbles under the decal. Which will result in accidental decal peeling.
|
|
2)WITHOUT PULLING OFF THE BACKING PAPER, Secure masking tape on each side of your decal and place on the windshield surface.
|
| 3)Place a longer piece of masking tape at the middle (To insure an easier install, try to place the tape between the spaces of the vinyl graphic). |
 |
|
|
4) Pull backing paper off by either ripping or cutting off half of the backing paper with a razor/exacto knife.
|
 |
5)Carefully squeegee the decal onto the surface starting from the middle and ending at the edge closest to you. |
|
|
6)Now that half of your decal is secure, peel the backing paper off of the rest of your decal and carefully squeegee the decal onto the surface starting from the middle and ending at the edge closest to you.
|
|
|
7) Finally, gently remove application tape by pulling straight back, leaving the decal on the surface.
|
| Decal Type/Size |
Dry Application |
Wet Application |
| Windshield Decals |
View
|
View
|
| Medium Sized Decals |
View
|
View
|
| Hood Decals/Large Decals |
Use wet method |
View
|
| Body/Accent Decal Kits |
Use wet method |
View
|
| Sun Visor Decals/Strip |
Use wet method |
View
|
| BackScapes Install |
View
|
Use dry method |
Please Note: Both Dry or Wet applications will give you the same results. You can choose to apply your decals via Wet or Dry methods. Due to their size we suggest a Wet application for Hood/Large and Body Decals.
|
|
|
